Add Toner Warning Indicator, Light Copies

Troubleshooting

2.The Toner Charging Mode starts and the LCD displays:

CHARGING TONER

Add Toner Warning Indicator:

CFlashing = Toner Bottle is nearly empty

CLit	= Toner Bottle is empty

3. This message is displayed for approximately 200 seconds.

CHARGING TONER

❚ ❚ ❚ ❚ ❚

∗ Each “ ❚ ” is approximately 10 sec.

4.This massage will continue to be displayed until the warm-up cycle is completed, and if the toner bottle was replaced. Upon completion, the Add Toner Warning Indicator automatically turns Off.

Check

Action

Light Copies

Does the exposure indicator say “Lighter”?

Press the Darker key until the indicator LED is set to Darker. (See page 12)

(Yes)

(No)

Does the add toner indicator and message appear on the display? (?)

Add Toner. (See page 39)

(Yes)

Marked Copies

Is the copier platen glass or platen cover dirty?

Clean the Glass or Platen Cover. (See page 48)

(Yes)

Others

Page 47

Image 47

Panasonic DP-1810F manual Add Toner Warning Indicator, Light Copies, Marked Copies

Contents

English Others Before StartingOptions Model and Serial Number Important Information Common Features and Usage Operation Chart Energy Star Table of Contents Others Problem SolvingOptions Manufacturer’s name and address Factory ID PrecautionsFor Your Safety Laser Safety Toner and Paper Ventilation Handling FCC Warning For U.S.A Installation Control Panel Original Size Key Contents Refer to Interrupt Key, Memory in Key, M1/M2 KeysAlarm LED Red Copy Size Key $Select Exposure Control Basic CopyFull Size Copying Copying the Same Size Originals Paper Tray key Copying with Preset RatiosReduction or Enlargement Copying ADF Tray Original Guides Automatic Document Feeder# Automatic Original Feeding $2 in 1 Copy Inappropriate Originals Face-Up Select Original Zoom CopyingZoom Copying on Special Paper, etc Using the Sheet Bypass$Adjust the side guides 1 key Creative FeaturesProcedure 1 Copy Copy Or Margin key Press BOOK, Edge $Press the Memory in F2 key Job MemoryTo Store a Job in Memory To Recall a Job Stored in Memory From Platen Glass only Sort ModeSort Copy Sort Copy Sleep Mode Other FeaturesEnergy Saver/Interrupt Mode Energy Saver Mode Normal Skyshot ModeDigital Skyshot Mode None Platen Upper Left Corner Manual Skyshot Mode Original Copy Combined Function TableOther Remarks Next Functions Job Memory Retrieval Selections Function Using Function Modes to Change the Initial Copy Modes General Functions Modes Function Initial Setting Modes Function Copier Settings General Functions for Key Operator Copier Settings for Key Operator Proceed as Follows Function SettingChanging the Auto Exposure Setting Functions Function Setting for Key OperatorChanging the Paper Size Size IndicatorPaper Stopper Guide a Paper Guide b Department Counter DEPT. Counter Mode Select the Department Counter Mode Components Accessories Sheet Paper Tray Problem SolvingAdding Paper J Cap Adding the Toner and Replacing Toner Waste Container ? Problem Solving Paper Misfeed Locations Removing a Misfed Paper Paper Exit Area Surface Paper Entry/Transport AreaHot Heated Paper Feed Module ADF Unit Does Not Operate TroubleshootingBefore Calling Service Check Action Marked Copies Add Toner Warning IndicatorLight Copies User Error Codes U Code Battery Replacement Procedure Replacing the BatteryBattery Replacement Required Message DP-1810F Copier Specifications 3rd Paper Feed Module DA-DS183 2nd/4th Paper Feed Module DA-DS182 For Network Printing / Email Internet Fax Options and SuppliesFor Printer For Fax Memo Warranty