Handling

Control Panel

Do not lift or lean against the Control Panel. The Control Panel can be broken which could result in injury.

Power Switch

Used to turn ON or OFF the Main Power Switch on the rear side of the machine and to turn ON or OFF the Power Switch on the left side of the machine.

Follow this procedure when turning OFF the Main Power of the machine:

-Turn OFF the Power Switch on the left side of the machine, wait a few seconds, and then turn OFF the Main Power Switch on the rear side of the machine.

If you are not going to use the machine for long periods of time, turn OFF the machine using the procedure above.

Do not turn OFF the Power Switch on the Left Side of the machine, or open the Front Cover during copying/printing.

Main PowerPower Switch
Switch (Rear(Left Side)

 

Side)

 

 

ON (

 

 

)

ON (

 

 

)

 

 

 

 

 

 

 

 

OFF (

)

 

OFF (

)

Auto Reset Time

The initial setting for Auto Reset Time is 1 minute. If you do not touch any key for 1 minute, the Touch Panel Display will return to the initial screen of the active function automatically. When reaching 20 seconds before resetting, the “Continue?” screen is displayed to allow you to extend the auto reset time for another 1 minute.

If you wish to change the Auto Reset Time, consult with your Key Operator.

Dept. (Department) Code

When the Department Counter function is set up, the Dept. (Department) Code input screen is displayed on the Touch Panel Display. A registered Department Code (1 to 8 digits) is required to gain access to each secured function, or the secured Copy/Scanner function(s) cannot be used. Please consult with the Key Operator regarding the Department Code(s) for the desired function.

How to enter the Dept Code:

Input a registered department code (1 to 8 digits). Select “OK”.

Product

Overview

Maximum Copies Limitation

After setting the maximum allowed number of copies for each department, consult with your Key Operator when the total copy count reaches the designated limit and the message appears on the Touch Panel Display.

Auto Image Density/Color Registration Adjustment Functions

This machine executes the following automatic adjustment periodically (approximately every 105 copies or print jobs). During the automatic adjustment process, copy job/print job will stop or jobs will be waited approximately 20 seconds.

(1)Auto Image Density

To adjust the print density even.

(2)Color Registration Adjustment To adjust the color registration.

Energy Saver (Power Save Mode, Sleep Mode)

You can set the machine to the Power Save mode or Sleep mode while the machine is not in use. In Power Save mode/Sleep mode, the Energy Saver key flashes or lights. Press the Energy Saver key to return the machine to its former operating screen. For more details, refer to General Settings (Key Operator Mode) in the Operating Instructions (For

Function Parameters) of provided CD-ROM.

It is normal operation that the machine makes sounds when switching into the Power Save mode.

 

 

 

Energy Saver key

 

 

 

 

 

 

Flashes: Power Save Mode

 

 

 

Lights : Sleep Mode

 

 

 

(Touch Panel Display

 

 

 

will be unlit)

 

 

 

ModesWarm Up Time

 

Power Save

Approx. 15 sec.

 

Mode

 

 

 

Sleep Mode

Approx. 15 sec.

 

 

 

 

 

 

Press the Energy Saver key while the machine is in the Sleep mode. The pop-up screen will be displayed while machine is warming up to ready.

PCMCIA/PC Card Slot

PCMCIA/PC Card Connector inside the PCMCIA/PC Card Slot is not supplied by Limited Power Sources.

11