Panasonic ET-CDWL2U, ET-CDWL3U, FT-LB10NTU, N5HBD0000028 manual Troubleshooting

Troubleshooting (cont.)

Symptom		Checkpoint
		• Check if the computer and the projector are located too far
		apart, or if some object is obstructing the radio waves.
		• Check that the IP address and the subnet mask are set
		correctly.
		• Is TCP/IP installed in the computer?
		• Does the WEP setting match with the projector?
		Communication is not possible if the WEP function is set
		when using a wireless card other than the optional card or
		when using an access point. In these cases turn off the WEP
		function.
The	projector	• In [Infrastructure] mode, set the same [SSID] for the projector
cannot be located		and the computer as that of the access point used. The
on the connection		[SSID] uses alphanumeric characters (case sensitive). In
list of	Wireless	addition, check that the computer control function that allows
Manager ME.		communication with access points is disabled.
		• In [802.11 AdHoc (Peer to Peer)] mode, set the same SSID
		for the projector and the computer. The SSID is case
		sensitive.
		• Is a network device other than the wireless card enabled?
		Check the Windows Device Manager.
		• Is proxy-client software active? Disable this software when
		communicating with the projector.
		• Are you running a security program that contains a personal
		firewall function? Before communicating data using the
		projector, either close the software or set up an exemption.
The	Wireless	• Right-click an empty location on the desktop and select
Manager ME color
display is strange		[Properties]. Then, open the [Settings] tab of the [Display
		Properties] window and set [Color quality] to [Medium (16 bit)]
and characters are
		or higher.
difficult to read.

56