Panasonic HDC-HS100PC operating instructions Quick start, Quick power on

Quick start

This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is reopened.

≥When in quick start standby mode about 70% of the power used in recording pause mode is being consumed, so the recording time will be reduced.

¬Rotate the mode dial to select .

1 Set the LCD/EVF select switch to LCD. (l 35)

2 Select the menu. (l 29)

[SETUP] # [QUICK START] # [ON]

3 Close the LCD monitor while the mode dial is set to .

The status indicator A flashes green and the unit goes into quick start standby mode.

≥The lens cover does not close.

4 Open the LCD monitor.

The status indicator A lights red and the unit is put into recording pause approx. 0.6 seconds after it is turned on.

≥Set [QUICK START] to [OFF] to cancel the quick start mode.

≥Quick start standby mode is canceled if jabout 5 minutes has elapsed jmode dial is set to

junit is turned off

≥Time for quick start will be more than 0.6 seconds slower in the following conditions. jWhen 24p digital cinema is used jWhen the unit is exposed to vibration or

shock

≥In the quick start mode, it may take some time for automatic white balance to adjust, if the scene being recorded has a light source different from the scene last recorded. (When the MagicPix function is used, however, the white balance of the scene last recorded is retained.)

≥In the quick start mode, the zoom magnification becomes 1k and the picture size may differ from what it was before quick start standby mode.

≥If [POWER SAVE] (l 31) is set to

[5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and then open it again.

Quick power on

(Only when recording to an SD card)

The unit is put into recording pause approx.

1.9seconds when the mode dial is set to from OFF.

≥ Start time will not shorten if you are recording to a HDD, or if there is no SD card inserted.

¬Rotate the mode dial to select .

1 Select SD card as a media to record from the menu. (l 29)

[MEDIA SELECT] # [SD CARD]

2 Select the menu. (l 29)

[SETUP] # [QUICK POWER ON] # [ON]

≥This function’s default setting is [ON].

≥Set [QUICK POWER ON] to [OFF] to cancel the quick power on.

≥In the quick power on mode, the zoom magnification becomes 1k and the picture size may differ from what it was before turning power off.

40

VQT1T93