Quick Guide

Charging the battery

Charging lamp

[CHARGE] A

Lights up:

Charging

 

 

Goes off:

 

Charging completed

1Connect the AC cable to the AC adaptor

and the AC outlet.

2Insert the battery into the AC adaptor by aligning the arrows.

Inserting the battery

Install the battery by inserting it in the direction shown in the figure.

AInsert the battery until it clicks and locks.

Inserting/removing an SD card

Access lamp [ACCESS] A

When this unit is accessing the SD card or built-in memory, the access lamp lights up.

1)Open the LCD monitor.

Check that the access lamp has gone off.

2)Open the SD card/terminal cover and insert (remove) the SD card into (from) the card slot.

Face the label side B in the direction shown in the illustration and press it straight in as far as it will go.

Press the center of the SD card and then pull it straight out.

3)Securely close the SD card/terminal cover.

Securely close it until it clicks.

Turning the unit on/off

Turning the power on and off with the power button

Press the power button to turn on the power.

AThe status indicator lights.

To turn off the power, hold down the power button until the status indicator goes off.

Turning the power on and off with the LCD monitor/viewfinder

Opening the LCD monitor or extending the viewfinder turns on the power. Closing the LCD monitor/viewfinder turns off the power.

To turn on the power

AThe status indicator lights on.

13

VQT2M75

Page 13
Image 13
Panasonic HDC-TM700K Quick Guide, Charging the battery, Inserting the battery, Inserting/removing an SD card