3-64 Features
S3 Features

System Data Default Set

This system can re-initialise the system-programmed data. If all the programmed data is
cleared, the system will reset using the default settings by program [999].
• The default setting for each programming item is listed in Section 5.1, Default Values.
• Required System Programming
[999] System Data Clear
• Installation Reference
2.23 System Data Clear
☞
!
!
(6) Duration : shows the duration of the call or the UCD call waiting time in
Hours/Minutes/Seconds.
(7) Code: shows the account code appended to the call, account code index number
(e.g.: 13) or the extension number which uses the Walking COS feature
(e.g.: 201).
• This system can store information of up to 64 calls.
• This data is not deleted even when the system is reset.
• If RECALL is manually sent out during a conversation to make another call without
hanging up, etc., a call record will be printed and a new record started. “F/” will be
printed at the beginning of the dial number on the new record.
• When a host PBX code is entered, “=” will be printed between the code and dialled
number.
• The language used for an SMDR printout can be selected in program [806].
• Connection Reference
2.13 Printer and PC Connection
• Required System Programming
[000] Date and Time Setting
[204] Call Duration Count Start Time
[800] SMDR RS-232C Communication Parameters
[801] SMDR Parameter
[802] Incoming/Outgoing Call Selection for Printing
[803] Secret Speed Dialling/One-Touch Dialling Printing
[804] System Data Dump
[805] SMDR Account Code Selection
[806] SMDR Language Assignment
• Related Feature Reference
Language Selection
!
!
☞
PSQX1708ZA-05E.QX 99.10.15 10:31 AM Page 64