System Programming 4-67
4.2 System Programming [522]-[523]
Assigns interval time between sending UCD outgoing messages to an incoming outside call
via the UCD feature when all extensions in the UCD group are busy. The UCD outgoing
message is repeated during the time programmed in [521] “UCD Busy Waiting Time”.
Default 1 minute
• Feature Reference
Section 3, Features
Uniform Call Distribution (UCD)

[522] UCD OGM Message Interval Time*1

2
5
NEXT
2
STORE
END
SELECT
(30 sec/1/
1.5/2 min)
☞
*1: Required only when the optional OGM/FAX Detection
Card is installed.
Selects the operation when the length of time programmed in [521] “UCD Busy Waiting
Time” expires. Intercept or Disconnect is available.
Intercept: The call will be redirected depending on programs [408]-[410] “Flexible
Ringing Assignment–Day/Night/Lunch”(Intercept Routing feature). The
extension which receives a redirected call rings during the length of time
programmed in [526] “UCD Ringing Time after Intercept”.
Disconnect:The call will be disconnected immediately.
Default Intercept
• The above-mentioned intercept only occurs when “MODE 3” or “MODE 5” is selected in
program [502] “OGM Mode Selection”. If “MODE 4” is selected,the call will be
disconnected after the UCD-END outgoing message. If “MODE 6” is selected and
“Intercept” is assigned in this program,the call will go to the DISA and OGM2 will be
heard by the caller.
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)

[523] UCD Busy Mode*1

2
5
NEXT
3
STORE
END
SELECT
(Intercept/
Disconnect)
!
!
☞
PSQX1708ZA-10E.QX 99.10.15 1:06 PM Page 67