Registration

• Registering a Handset to a Base Unit (rreeggiisstteerr hhss)

The handset supplied with the base unit is already registered. If an optional

handset/base unit is purchased, the following procedure needs to be carried out

before initial use.

Zand Hold Ïon base unit for 10 secs.A confirmation tone sounds.
36
-1-888888800
ÂÊÁËÈÍ
QÏÔÓÒ
(Standby Mode)
newspeed
ÂÊÁËÈÍ
ÎÏÔÓÒ
ZYor V
settinghs
ÂÊÁËÈÍ
ÎÏÔÓÒ
ZSor U
ZSor U
ZYor V
Z
Yor V
timealarm
ÂÊÁËÈÍ
ÎÏÔÓÒ
registration
ÂÊÁËÈÍ
ÎÏÔÓÒ
Z
Yor V
base2
ÂÊÁËÈÍ
ÎÏÔÓÒ
S U
base4
ÂÊÁËÈÍ
ÎÏÔÓÒ
• Select base unit.
ZYor V
• (“Hyphen” is moving during
searching).
Connection OK.
• Enter PIN (4 digits).
• Base is found.
• On completion of
registration, a
confirmation tone
sounds.
• If registration is not
successful within
5 minutes, an error
tone sounds and
display returns to
original standby
mode.
ZYor V
(Searching Base).
bs9pin É
ÂÊÁËÈÍ
ÎÏÔÓÒ
88-888888888
ÂÊÁËÈÍ
QÏÔÓÒ
-2-888888801
ÂÊÁËÈÍ
ÎÏÔÓÒ
registerhs
ÂÊÁËÈÍ
ÎÏÔÓÒ
S U
cancelbase
ÂÊÁËÈÍ
ÎÏÔÓÒ
NOTES:
• Charge the optional handset batteries for about 10 hours
before initial use.
• Register the handset within 1 minute. If not registered
within 1 minute, ZPon the handset to cancel the
programming mode. Then re-start registration.
• Calls (both incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio areas overlap
with neighbouring base units).
Note:
• To return to the previous step during programming, ZT.
• To exit the programming mode at any time, ZP.
See Page 37.
31939_KX-TCD700CX_Czech 18/6/01 1:54 pm Page 36