To Select the Base Unit Ringer Volume
4 levels are available. The factory pre-set is MEDIUM. When set to OFF, the
base unit will not ring.
To Select the Dialling ModeYou can program the dialling mode to tone or pulse. If you have touch tone
service, set to tone. If rotary or pulse service is used, set to pulse. The factory
pre-set is tone.
Setting the ClockTo set clock, please program as below. The clock can be displayed as an option
in standby mode (see page 31). After a power failure the clock will need re-
setting. Clock may take up to one minute to appear on the handset display.
(Standby Mode)
Z
Yor V
Z
Sor U
Z
Yor V
-1-888888801
ÂÊÁËÈÍ
ÎÏÔÓÒ
newspeed
ÂÊÁËÈÍ
ÎÏÔÓÒ
settingbs
ÂÊÁËÈÍ
ÎÏÔÓÒ
inputcode
ÂÊÁËÈÍ
ÎÏÔÓÒ
• Setting the Clock.
ZJ
• If the clock has been set
previously, time will be
displayed.
Enter new time (4-digits)
eg. ZA
ZB,C,D
(24 hour clock)
• Aconfirmation tone sounds.
• Display returns to function
menu.
ZY
Ø œœ–œœ
ÂÊÁËÈÍ
ÎÏÔÓÒ
Ø1–834000000
ÂÊÁËÈÍ
ÎÏÔÓÒ
Ø12-34000001
ÂÊÁËÈÍ
ÎÏÔÓÒ
settingbs
ÂÊÁËÈÍ
ÎÏÔÓÒ
➡
41
Current setting is displayed.
ZK- Cto select
volume
0 = Ringer OFF
1 = Low Volume
2 = Medium Volume
3 = High Volume
(Ringer sounds on selection)
ZYor V
• Select Ringer Volume
ZB
ZB
221
ÂÊÁËÈÍ
ÎÏÔÓÒ
2222
ÂÊÁËÈÍ
ÎÏÔÓÒ
• Aconfirmation tone sounds.
• Display returns to function
menu.
settingbs
ÂÊÁËÈÍ
ÎÏÔÓÒ
Current setting is
displayed.
ZA- Bto
select Dial Mode.
1 = Tone Dial Mode.
2 = Pulse Dial Mode.
ZYor V
ZA
•Select Dial Mode
(Tone/Pulse).
ZC
Enter PIN(4 digits).
3 œœœœ
ÂÊÁËÈÍ
ÎÏÔÓÒ
3221
ÂÊÁËÈÍ
ÎÏÔÓÒ
3121
ÂÊÁËÈÍ
ÎÏÔÓÒ
• Aconfirmation tone
sounds.
• Display returns to
function menu.
setting bs
ÂÊÁËÈÍ
ÎÏÔÓÒ
Chapter 4
31939_KX-TCD700CX_Czech 18/6/01 1:54 pm Page 41