Useful Information
37

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Initial settings

Problem Cause & solution
w is flashing. LThe handset is not registered to the base unit.
Register it (page 31).
LThe handset is too far from the base unit. Move
closer.
LThe AC adaptor is not connected. Check the
connections.
The handset display is blank. LThe handset is not turned on. Turn the power on
(page 12).
The handset will not turn on. LMake sure that the batteries are installed correctly
(page 11).
LFully charge the batteries (page 11).
LClean the charge contact and charge again (page
11).
TG1805AL(e-e).book Page 37 Thursday, March 17, 2005 9:37 AM