Feature/Code Selection
Setting the ADSL mode
MBNM1NM2NM4N
(KX-MB1520 only)
When you use a DSL/ADSL line, this feature improves the reliability by reducing
the transmission speed.
M0N “OFF” (default)
M1N “ON”
Note:
RCalling charges may be higher than usual.
Changing the LCD display
contrast
MBNM1NM4NM5N
M1N “NORMAL” (default)
M2N “DARKER”
Selecting the scale
MBNM1NM4NM7N
M1N “MILLIMETERS”
M2N “INCHES” (default)
Note:
RThe selected scale will be used when measurements are shown on the
unit’s display.
Changing the password for
feature programming via
remote operation
MBNM1NM5NM5N
1. MMenuN A MBNM1NM5NM5N A MSetN
2. Enter the current password. A MSetN
RThe default password is “1234”.
3. Enter a new 4-digit password using 0-9. A MSetN
4. Enter the new password again. A MSetN A MMenuN
Note:
RIt is recommended that you change this password from the default
password.
Setting the toner
maintenance time
MBNM1NM5NM8N
(KX-MB1520 only)
The unit will automatically activate for maintenance, once every 24 hours.
Because this is to prevent the toner from solidifying, the noise that the unit
makes during maintenance cannot be stopped. However, if the unit’s noise
bothers you, you can change the start time.
1. MMenuN A MBNM1NM5NM8N A MSetN
2. Enter the maintenance start time.
RThe default time is “12:00PM”.
RPress MGN repeatedly to select “AM” or “PM”.
3. MSetN A MMenuN
Resetting all features (and
deleting all data in memory)
MBNM1NM5NM9N
Before you dispose of, transfer or return the product, activate this feature to
reset all programmable features and to delete all data stored in memory.
KX-MB1520 only: Phonebook (or caller information) and fax transmission data
(journal report and faxes received in memory) will be deleted.
M0N “NO” (default)
M1N “YES”
RDisconnect the telephone line cord (KX-MB1520 only) and USB cable
before activating this feature.
To reset all features:
1. MMenuN A MBNM1NM5NM9N
2. Press M1N to select “YES”. A MSetN
3. Press M1N to select “YES”. A MSetN
Setting the ringer pattern
MBNM1NM6NM1N
(KX-MB1520 only)
M1N “A” (default)
M2N “B”
M3N “C”
47
9. Programmable Features