18
Maintenance
Water supply hose filter / Ag Air-filter / Lint filter / Main unit and tub
1. Turn off the water faucet.
2. Press the [Power On] button.
3. Press the [Start/Pause] button.
The Water Level will light up a few seconds later.
4.
Press the [Power Off] button to turn off the power.
5. Loosen the nut.
6. Take off the hose.
7. Clean the filter.
Water supply hose filter
• When water supply seems constricted.
• Be absolutely sure to follow
the procedures as described,
otherwise water will spray out.
Lint filter • Remove the accumulated lint regularly. When the filter is full of lint, the filter could
be torn from rubbing with the laundry during washing cycles.
1(Lint filter A)
Remove the lint
filter A.
23(Lint filter A)
Put the filter back in.
Make sure it clicks
into place.
1(Lint filter B)
Pull out the lint filter B
from the lock.
By using fingers to
press and pull out at
the upper part of the lint filter’s side.
Remove the lint
from the filter.
3(Lint filter B)
Set it back to the
original position.
• Insert the bottom
first as shown in the figure.
•
Press down and lock as the arrow.
• When the filter is torn, etc., obtain another one from the place of purchase.
• Turn the wash tub if the filter cannot be removed easily.
1
2
12
• Upper part of the tub
Wipe with a damp cloth.
✻ Do not apply water directly.
The floor could get wet.
Main unit and tub
• Main unit
Wipe with a soft cloth. Use a neutral dishwashing liquid or soap
for stubborn places.
✻ Do not apply water directly.
✻ Do not use cleanser, paint benzine, alcohol, kerosene, etc.
✻ Follow any instructions that come with a chemically treated cloth.
1
2
12
Ag Air-Filter
✻ Do not wash
with water.
1 Remove the filter cover, then
pull out the Ag Air-Filter. 2 Remove any kind of dust
from the filter. 3 Set it back to the original position
by pressing the left /right sides of
the filter cover.
✻ Do not press the middle of the
filter cover.
Maintenance
To prevent from fungus growth at the outer tub area.
“Tub Dry”
Remark: Please be informed do not put laundry inside the tub during this Program.
1Press the [Power On] button.
2Press the [Program] button 6 times
for [Tub Hygiene] Course.
• The [Tub Hygiene] light will be indicated.
3Press the [Wash] button and the [Rinse] button once each to select only [Spin].
4Press the [Start/Pause] button. • Spinning operation will be operated for 30 minutes
The buzzer lets you know when the washing is finished.
1
2
4
3
NA-F90H2_EN_AR-PE-V2.indd 18 11/23/11 3:41:38 PM