Panasonic NV-GS120GN Power Supply, Using the Remote Controller, Using the AC Adaptor

Before Use

WARNING

Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 100xC or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed call your doctor.

ªUsing the Remote Controller

1Direct the Remote Controller at the Remote Control Sensor (29) of the Movie Camera and press an appropriate button.

≥When the battery in the Remote Controller is replaced, the mode is automatically reset to [VCR1] Mode.

Power Supply

ªUsing the AC Adaptor

1

	10˚
15˚	(29)
	15˚
	15˚

≥Distance from the Movie Camera: Within approximately 5 metres

≥Angle: Within approximately 10o in the upward, and 15o in the downward and horizontal directions from the central axis

≥The above operating ranges are for indoor use. Outdoors or under strong light, the Movie Camera may not operate properly even within the above ranges.

≥Within a 1-metre range, you can also use the Remote Controller on the LCD Monitor side of the Movie Camera.

Selecting Remote Controller Modes

When 2 Movie Cameras are used simultaneously, they can be operated individually by selecting different Remote Controller Modes.

≥If the Remote Controller Mode of the Movie Camera and that of the Remote Controller do not match, [REMOTE] Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [INITIAL] Sub-Menu to the desired Remote Controller Mode. (-16-)

Setup on the Remote Controller:

	6	1	5
2	STILL ADV PAUSE STILL ADV			1
	E	;	D
	INDEX	STOP	INDEX	P.B. ZOOM
	K	∫	L

SELECT

[VCR1]:

Press the [D] Button and [∫] Button simultaneously. 1

[VCR2]:

Press the [E] Button and [∫] Button simultaneously. 2

1Connect the DC Input Lead to the Movie Camera.

2Connect the DC Input Lead to the AC Adaptor.

3Connect the AC Mains Lead to the AC Adaptor and the AC mains socket.

≥The AC Mains Lead’s outlet plug does not fit

entirely into the AC Adaptor socket. A gap will remain as shown 1.

≥Before connecting or disconnecting the power supply, set the [OFF/ON] Switch on the Movie Camera to [OFF] and make sure that Power Lamp is not lit.

ªUsing the Battery

Before use, fully charge the Battery.

≥We recommend using Panasonic’s Battery. ≥We cannot guarantee the quality of this Movie

Camera when batteries of other companies are used.

1Attach the Battery to the AC Adaptor and charge it.

≥Since the Battery will not be charged when the DC Input Lead is connected to the AC Adaptor, disconnect it from the AC Adaptor.

≥The [CHARGE] Lamp lights up, and charging starts.

≥When the [CHARGE] Lamp goes off, charging is completed.

-8-