
Record mode
Check the recording
The last image recorded is played back for 2 to
3 seconds. After checking, the camera will be set to a recording pause.
$Set to Tape Recording Mode.
1Press the joystick during the recording pause until the icon ! appears.
2Move the joystick down to select the recording check icon [ ].
!
Blank search function
Searches for the last part of the image recorded (unused part of the tape).
$Set to Tape Recording Mode.
1Set [BASIC] >> [BLANK SEARCH] >> [YES].
%Stopping blank search midway
through
Move the joystick down to select the [5] icon.
$If the cassette tape has no blank part, then the camera will stop at the end of the tape.
$The camera stops at a point approx. 1 second before the end of the last image recorded. When you start recording at that point, the image can be recorded seamlessly from the last image.
Recording still pictures onto a card (Photoshot)
$Set to Card Recording Mode.
1Press the [PHOTO SHOT] ]
focuses on the subject automatically.
PHOTO
SHOT
1
2
!Shutter chance mark
8 (The white lamp flashes.): Focusing
/ (The green lamp lights up.): When in focus
No mark: When focusing is unsuccessful $The shutter chance mark is indicated as follows
when the [PHOTO SHOT] ]
/(The green lamp lights up.):
When in focus and a good picture can be recorded
8(White lamp lights up.): Almost in focus
"Focus area
2Press the [PHOTO SHOT] ]
%To record still pictures clearly $When zooming in on the subject with a
magnification of*49 to 109 or higher, it is difficult to reduce the slight shaking from holding the movie camera by hand. We recommend decreasing the zoom magnification and approaching the subject when recording.
$When recording still pictures, hold the movie camera firmly with your hands and keep your arms stationary at your side so as not to shake the movie camera.
$You can record stable pictures without shaking by using a tripod and the remote control.
22
VQT0T87