Before using
14
LSQT1291
Using the viewfinder
ªExtending the viewfinder
1Pull out the viewfinder and extend it by
pinching the extension knob.
≥The viewfinder will be activated. (If the LCD
monitor is opened, the viewfinder will be
deactivated.)
ªAdjusting the field of view
1Adjust the focus by sliding the eyepiece
corrector knob.
≥You can adjust the brightness of the viewfinder
from the menu.
Quick start
When quick start is on the battery power is still
being consumed, even when the LCD monitor
and the viewfinder are closed.
The camera will resume recording/pause mode
about 1.7 seconds after the LCD monitor or the
viewfinder is reopened.
≥Please note in quick start mode approximately
half the pause recording power is being
consumed. Using quick start mode will reduce
the battery recording/playback time.
≥This is only activated in the following cases.
≥While using the battery
A tape is inserted, while the Tape Recording
Mode is set.
≥While using the AC adaptor
Quick Start can be used even if a tape is not
inserted.
≥Set to Tape Recording Mode.
1Set [SETUP] >> [QUICK START] >> [ON].
(-18-)
2Close the LCD monitor and retract the
viewfinder while the mode dial is set to
Tape Recording Mode.
≥The status indicator lights green and the unit
goes into quick start standby mode.
≥The movie camera will not go into quick start
standby mode unless the LCD monitor is
closed and the viewfinder is retracted.
3Open the LCD monitor or extend the
viewfinder.
≥The status indicator lights red and the camera
is put into recording pause approx.
1.7 seconds after it is turned on.

12:34:5612:34:5612:34:56

1. 1. 20081. 1. 20081. 1. 2008

12:34:56

1. 1. 2008

LSQT1291_ENG.book 14 ページ ２００８年３月５日　水曜日　午前９時４１分