Panasonic NV-GS90 operating instructions Inserting/removing a cassette, To cancel Quick Start

Before using

ªTo cancel Quick Start

1Set [SETUP] >> [QUICK START] >> [OFF]. (-18-)

≥The status indicator goes off and the power turns off if the mode dial is set to OFF while the unit is in quick start standby mode.

≥If the standby continues for approx. 30 minutes, then the status indicator will go off and the camera will be completely turned off.

≥In the following cases, quick start is cancelled and the power turns off.

≥When the Mode dial is moved.

≥When the battery or AC adaptor is removed. ≥When the tape is removed while using the

battery in Tape Recording Mode. ≥When the movie camera is quick-started with

the white balance on automatic, it may take some time until the white balance is adjusted if the scene being recorded has a light source different from the scene last recorded. (When the colour night view function is used, however, the white balance of the scene last recorded is retained.)

≥If the power is turned on in quick start standby mode, the zoom magnification becomes 2k and the picture size may differ from what it was before quick start standby mode.

≥If [POWER SAVE] (-39-) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and retract the viewfinder and then open the LCD monitor or extend the viewfinder again.

Inserting/removing a cassette

1Fit the AC adaptor or the battery and turn on the power.

2Slide the [OPEN/EJECT] lever and open the cassette cover.

OPEN/

EJECT

≥When the cover is fully opened, the cassette holder will come out.

3After the cassette holder is opened, insert/ remove the cassette.

≥When inserting a cassette, orient it as shown in the figure, and then securely insert it as far as it goes.

≥When removing, pull it straight out.

4Push the [PUSH] mark 1 in order to close the cassette holder.

1

PUSH

≥The cassette holder is housed.

Caution:

Take care not to trap your fingers under the cassette holder when closing it.

5Only after the cassette holder is completely housed, close the cassette cover tightly.

≥When inserting a previously recorded cassette, use the blank search function to find the position where you want to continue recording. If you are overwriting a previously recorded cassette, be sure to find the position where you want to continue recording.

≥When closing the cassette cover, do not get anything, such as a cable, caught in the cover.

15

LSQT1291