–Windows XP Service Pack 2 or later.
Note:
RA USB cable is not supplied. Please purchase a
shielded Type-A male/Type-B male USB cable.

2.12.2 Installing Multi-Function Station on a

computer

RInstall Multi-Function Station (CD-ROM) before
connecting the unit to a computer with the USB
cable. If the unit is connected to a computer with
the USB cable before installing Multi-Function
Station, the [Found New Hardware Wizard] dialog
box will appear. Click [Cancel] to close it.
RThe screenshots shown in these instructions are
for Windows XP and are included for reference
only.
RThe screenshots shown in these instructions
may differ slightly from those of the actual
product.
RSoftware features and appearance are subject to
change without notice.
RIf you are also using KX-MB200/KX-MB700/
KX-FLB880 series, see page 84.
1Start Windows and exit all other applications.
RYou must be logged in as an administrator in
order to install Multi-Function Station.
2Insert the supplied CD-ROM into your CD-ROM
drive.
RIf the [Select Language] dialog box appears,
select the language that you want to use with this
software. Click [OK].
RIf the installation does not start automatically:
Click [Start]. Choose [Run...]. Type “D:\Install”
(where “D” is the drive letter of your CD-ROM
drive). Click [OK].
(If you are not sure what the drive letter is for your
CD-ROM drive, use Windows Explorer and look
for the CD-ROM drive.)
3[Easy Installation]
RThe installation will start automatically.
4When the setup program starts, follow the on-screen
instructions.
REasy Print Utility (page 29), Readiris OCR
software (page 31) and Device Monitor
(page 72) will also be installed.
5The [Connect Type] dialog box appears.
For USB connection:
1. [Connect directly with a USB cable.] A [Next]
RThe [Connect Device] dialog box will appear.
2. Connect the unit to a computer with the USB cable
(A), then click [Next].
A
* The pictured model is KX-MB2030.
RIf the unit is connected to your computer, the
model name will be automatically detected.
RYou can change the name of the unit if necessary.
3. Click [Install], then follow the on-screen instructions.
RThe files will be copied to your computer.
For LAN connection:
1. [Connect via the Network.] A [Next]
RThe [Select a Network Device] dialog box will
appear.
2. Check [Select in the searched list] and select the
unit from the list.
RIf the name of the desired unit is not displayed on
the list, and the IP address for the unit has been
assigned, check [Direct input] and enter the IP
address.
3. [Next]
RYou can change the name of the unit if necessary.
4. Click [Install], then follow the on-screen instructions.
RThe files will be copied to your computer.
Important notice
If you are using Windows XP, Windows Vista or
Windows 7, a message may appear after connecting
the unit with the USB cable. This is normal and the
software will not cause any difficulties with your
operating system. You can continue the installation
with no problem. This kind of message is displayed:
RFor Windows XP users
“The software you are installing for this hardware
has not passed Windows Logo testing to verify its
compatibility with Windows XP.”
RFor Windows Vista/Windows 7 users
“Would you like to install this device software?”
To view or install the operating instructions data
1. Start Windows and insert the supplied CD-ROM into
your CD-ROM drive.
2. Click [Operating Instructions], then follow the
on-screen instructions to view or install the operating
instructions in PDF format.
RAdobe® Reader® is required to view the operating
instructions.
For assistance, please visit http://www.panasonic.com/help 25
2. Preparation