11.2 Display messages
To indicate the unit’s status, one or more of the following messages will appear on the display.
Display Cause & Solution
“CALL SERVICE”RThere is something wrong with the unit. Contact our service personnel.
“CHANGE DRUM”RThere is something wrong with the drum cartridge. Replace the drum
cartridge and the toner cartridge.
“CHECK DOCUMENT”RThe document was not fed into the unit properly. Remove the document,
and then press MStopN to clear the message. Re-insert the document. If
misfeeding occurs frequently, clean the document feeder rollers
(page 95) and try again.
“CHECK DRUM”RThe drum cartridge is not inserted properly. Re-insert it correctly (page 10).
“CHECK PAPER #1”RRecording paper is not installed or the paper input tray has run out of paper.
Install paper (page 14).
RRecording paper was not fed into the unit properly. Re-insert the recording
paper (page 89).
RThe paper input tray is not installed or is not inserted completely. Insert the
paper input tray into the unit.
“CHECK PAPER TRAY #1”RThe loaded recording paper is not the appropriate size. Load recording
paper of the size that is shown on the display.
RIf this message is often displayed, also change the recording paper size
setting (feature #380 on page 57).
RThe recording paper size setting (feature #380 on page 57) is set to
“B5(ISO)”, “B5(JIS)” or “16K”, so received faxes have been stored into
memory. Change the recording paper size setting and load the appropriate
recording paper.
Note:
R“#1”: Check the paper input tray. The displayed paper size depends on the
recording paper size setting (feature #380 on page 57).
R“#2”: Check the manual input tray. The displayed paper size depends on
the recording paper size setting (feature #381 on page 57).
“CHECK PICK UP INPUT
TRAY #2”
RRecording paper was not fed into the unit properly. Load the paper again
(page 89).
“CHECK REAR COVER”RThe manual input tray (rear cover) is open. Close it.
RA recording paper jam occurred near the manual input tray (rear cover).
Remove the jammed paper (page 85).
“COOL DOWN FUSER”RThe unit is cooling down the fuser unit. Wait for a while.
“DRUM LIFE LOW REPLACE
SOON”
RThe drum is reaching the end of its life. Replace the drum cartridge and the
toner cartridge as soon as possible.
“EMAIL SIZE OVER”RWhen performing scan to email address, the total file size of scanned data
exceeded the file size limitation. Divide the document into sections.
RWhen performing scan to FTP server or scan to SMB folder, the total file
size of scanned data exceeded the file size limitation. Divide the document
into sections.
74 For assistance, please visit http://www.panasonic.com/help
11. Help