Panasonic PT-L735E, PT-L735NTE dimensions Location and function of each part

Location and function of each part

Projector <Top, right and front>
PT-L735NTE only		#$	%	&	'
1	2
3 4
					(
0
*
-
,
/			. -, +	*	)

Projector <Back and bottom>		Preparation
$ %	&

#

'

(

#Focus ring (page 24)

$Zoom ring (page 24)

%Projector control panel (page 14)

&Connector panel (page 16)

'MAIN POWER switch (pages 23 and 25)

(Power input socket (AC IN) (page 23)

The accessory mains lead is connected here.

Do not use any mains lead other than the accessory mains lead.

)Speaker (L)

*Air inlet ports

Do not cover these ports.

+Air filter (page 54)

,Front adjustable legs(L/R) (page 24)

-Leg adjuster buttons(L/R) (page 24)

These buttons are used to unlock the front adjustable legs. Press to adjust the angle of tilt of the projector.

.Remote control signal receptor (page 22)

/Lens cover

0Projection lens

1Wireless card slot (PT-L735NTE only)

Insert the wireless card into here. (Refer to page 17.)

2Eject switch (PT-L735NTE only)

Use to remove the wireless card from the card slot.

3Access lamp (PT-L735NTE only)

Flashes while the projector is being accessed for reading or writing the data in the SD memory card.

4SD memory card slot (PT-L735NTE only)

Insert the SD memory card into here.

#Security lock

This can be used to connect a commercially-available theft- prevention cable (manufactured by Kensington). This security lock is compatible with the Microsaver Security System from Kensington. Contact details for this company are given below.

Kensington Technology Group ACCO Brands Inc.

2855 Campus Drive

San Mateo, CA 94403 USA Tel (650)572-2700

Fax (650)572-9675 http://www.kensington.com/ http://www.gravis.com/

NOTE:

BInformation given above may be changed in future.

$Remote control signal receptor (page 22)

%Air outlet port

Do not cover this port.

&Carrying handle 'Speaker (R)

(Lamp unit holder (page 56)

WARNING

Do not bring your hands or other objects close to the air outlet port.

BHeated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand heat close to this port, otherwise burns or damage could result.

NOTE:

BDuring projection of an image, the cooling fan will operate, emitting a small noise as it operates. Turning the lamp on or off will cause this noise to increase a little.

BBy using the OPTION menu to set LAMP POWER to “LOW”, the operating sound of the fan can be reduced. (Refer to page 46.)

12-ENGLISH ENGLISH-13