Panasonic PV-HS2000 operating instructions Searching for Your Component’s Code, 2 TV

Searching for Your

Component’s Code

If your component does not respond to the Hard Disk Recorder remote after trying all of the codes listed for your brand, or if your brand is not listed, try searching for your code.

For example, if you try all of the codes for your TV and cannot get the Hard Disk Recorder remote to operate your TV, follow steps below.

1	Turn on your TV with the Hard Disk
	Recorder off.
2	Press TV.
3	Hold down CODE SET until the remote’s red
	LED blinks twice, then release.
4	Press 9 - 9 - 1.
5	Slowly alternate between pressing POWER*
	and TV until your TV turns OFF.

•Make sure that the Hard Disk Recorder remote is aimed at your TV during the search.

•You may have to press this sequence of buttons (POWER* then TV) up to 100 times to search the entire library of codes.

*If you are searching for your VCR, or DVD player code, you may want to use PLAY instead of POWER to search for your code. When your VCR starts to play, press CODE SET to lock in your code.

6	When your TV turns OFF, press CODE SET
	to lock in the code for your TV.

•Your Hard Disk Recorder remote is now programmed to operate your TV.

NOTE

•To search for the codes of your other components, repeat steps 1~6, and substitute the appropriate device button (TV, SAT/CABLE, or VCR/DVD) for the component.

Red LED

3 CODE SET

6

5 POWER

VCR/DVD

SAT/CABLE

2 TV

5

4 Number

Buttons

PLAY

43