Panasonic PV-HS2000 Specifications & Information, Resetting Hard Disk Recorder, Screen Burn

Specifications & Information

Specifications

General
Operating voltage	120VAC 60Hz
Power Consumption	28W (Power On)
	19W (Power Off)
Tuner
MTS
Input Connectors
Tuner	Type F
Composite	Phono x 2
Audio	Phono (L+R) x 2
S-Video	4-pin miniature DIN
Output Connectors
Composite	Phono x 2
Audio	Phono (L+R) x 2
S-Video	4-pin miniature DIN
Telephone	RJ-11, 2wire
Serial Control	DB-9
IR Blaster
Dimensions/Weight
Height	76mm
Width	430mm
Depth	290mm
Weight (net)	5.9kg
Audio/Video Signals
Audio output level	2.0Vp-p
Video output level	1.0Vp-p
Video output impedance	75 ohm
Operating/Storage Conditions
Operating temp. range	+5°C to +40°C
Storage temp. range	-20°Cto +55°C for 100 hours
Record
HDD Capacity	20.4GB
Video compression format	MPEG2
Audio compression format	MPEG1 layer2
Recording level	Extended/Medium/High
Recording time	30H/15H/10H*
MODEM
Speed	56kbps

*Actual available recording time is not maximum because the “Welcome Video” is already recorded in the Replay Guide. To make the most of the available recording time, delete the welcome video from the Replay Guide or save it to a videotape.

Resetting Hard Disk Recorder

If the Hard Disk Recorder does not respond when you press buttons on the remote, press and hold the POWER button on the front of the unit for 10 seconds. The Hard Disk Recorder will start up in a few moments.

The Hard Disk Recorder’s green power LED does not need to be lighted to record shows. If you have a cable box or a satellite receiver, however, these device must remain on for the Hard Disk Recorder to record from them.

Screen Burn In

When any image is displayed on a television screen for an extended period of time, a permanent mark can remain even after the image is changed. This is called “screen burn in.” Projection TVs are the most susceptible to screen burn in. To prevent this, don’t leave the Channel Guide, or any other screen displayed when you don’t need to use them. You can also adjust the brightness of the Hard Disk Recorder screens to help prevent this. See “Change Display Brightness” on page 7.

NOTE

•To dismiss the Pause on-screen image from your TV screen and keep a show paused, press the EXIT button on the remote control.

53