EVF or LCD Monitor (Record/Pause mode)

Camera Recording

Recording via EVF or LCD Monitor

View recording scene on EVF (Electronic Viewer Finder) or LCD (Liquid Crystal Display) monitor.

1

Before you begin...

Connect Camcorder to power source.

Insert cassette with record tab (page 12).

1 Press LCD-OPEN to unlock the LCD monitor. Swing LCD monitor fully open and adjust viewing angle.

2 Set POWER to

CAMERA.

CAUTION

Rotating partially open LCD monitor may block cassette door and damage Camcorder body.

4, A, B

• Be sure POWER is fully turned to CAMERA position.

EVF or LCD monitor

turns on/off by the POWER switch.

Both EVF and LCD monitor turn on when LCD is at 180° (see above left). This allows both you and the subject to view the recording.

3

Built-in

Microphone

LCD : Adjust LCD monitor brightness level. See “To adjust LCD BRIGHT” below.

EVF : Look into EVF and adjust VISION ADJUSTMENT to your preference.

3VISIONADJUSTMENT

To adjust LCD BRIGHT

APress MENU for MENU mode.

Press UP or DOWN to select

LCD BRIGHT .

BPress M.FOCUS for

LCD BRIGHT SETTING menu.

Press UP or DOWN to adjust LCD monitor brightness level.

2, 6

5

4 Set REC MODE to “SP” or “SLP” in the CAMERA MODE Menu (page 14).

5 Press RECORD/PAUSE to start or pause recording.

6 Set POWER to OFF when finished.

To remove the cassette, slide the TAPE EJECT switch (page 12).

Note:

When Camcorder is aimed at excessively bright objects, or bright lights, a vertical bar may appear in the picture. This is normal for the CCD pick-up. Try to avoid this when possible.

Using LCD monitor reduces battery operation time. Return LCD monitor to locked position when not in use.

18

For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo

Page 18
Image 18
Panasonic PV-L354 To adjust LCD Bright, APress Menu for Menu mode Press UP or Down to select, BPress M.FOCUS for