Panasonic SC-BTX70 Network settings, Testing of IP Address / DNS Settings, Setting the IP address

Network settings

These settings are used if you will connect this unit to the Internet. (> 38)

≥The connection to the Internet may take time or the Internet may not be connected depending on the connection environment. It is required that you use a broadband connection.

Preparation

≥Connect to a broadband network. (> 11)

Testing of “IP Address / DNS Settings”

Always test the connection when a LAN cable is connected.

1While stopped

Press [BD/SD] to select “BD/DVD”.

2Press [SETUP].

3Press [3, 4] to select “Network Settings” and

press [OK].

4Press [3, 4] to select “IP Address / DNS Settings” and press [OK].

5Press [3, 4] to select “Connection Test” and press [OK].

IP Address/DNS Settings
Connection Test
IP Address Auto-Assignment	On
IP Address
Subnet Mask
Gateway Address
DNS-IP Auto-Assignment	On
Primary DNS
Secondary DNS
Connection Speed Auto-Config	On
Connection Speed Setting
OK
RETURN

“Testing...”: The test is in progress.

“Pass”:	The connection is completed.
“Fail”:	Press [RETURN] to exit.
	Please check the connection and settings.

≥Perform the “Connection Test” also when any change was made to the “IP Address / DNS

Setting the IP address

In most cases, default settings can normally be used without making any changes.

Set the IP address only when the router has no DHCP server functions or when the router’s DHCP server function is disabled.

After performing steps 1 – 4 (D left)

5Press [3, 4] to select “IP Address Auto-Assignment” and press [2, 1] to select “Off”.

6Press [3, 4] to select “IP Address”, “Subnet Mask” or “Gateway Address” and press [OK].

7Enter numbers with the numbered buttons and press [OK].

≥After checking the specifications for your broadband router, enter each number.

If the number is unknown, then check the number of other devices such as personal computers connected via a LAN cable. Assign a different number from those of other devices for the “IP Address” and the same number for others.

≥If a wrong number is entered, then press [CANCEL].

8Press [2, 1] to select “Yes” and press [OK].

≥The numeric input range is between 0 and 255.

NOTE

Setting the DNS-IP

In most cases, default settings can normally be used without making any changes.

When setting an assigned DNS server from your Internet service provider, perform the following settings.

NOTE

Settings”.

After performing steps 1 – 4 (D left)

≥If the connection test fails, it may be necessary to set the MAC address of this unit at the router side. The MAC address can be displayed by pressing [SETUP] and selecting “Network Settings”.

Network Settings

IP Address / DNS Settings

Proxy Server Settings

Network Service

MAC Address: xx-xx-xx-xx-xx-xx

OK

RETURN

5Press [3, 4] to select “DNS-IP Auto-Assignment” and press [2, 1] to select

“Off”.

6Press [3, 4] to select “Primary DNS” or

“Secondary DNS”and press [OK].

7Enter numbers with the numbered buttons and press [OK].

≥Follow the instructions given by your Internet service provider and enter the numbers.

If the number is unknown, then check the number of other devices such as personal computers connected via a LAN cable and assign the same number.

≥If a wrong number is entered, then press [CANCEL].

Primary DNS

Please input Primary DNS and press

[OK]. Press [CANCEL] to delete the selected character. To clear this setting, delete all characters and press [OK].

192			.	1	.	.
		- 9	Number
	0

8Press [2, 1] to select “Yes” and press [OK].

≥The numeric input range is between 0 and 255.

Advanced operations

NOTE

RQT9464

31