Adjusting Pos./Size

1

2

3

4

Press to display the Pos./Size menu. Press to select the menu to adjust.

Press to adjust the menu.

Press to exit from adjust mode.

Pos./Size

Normalise

Normal

 

 

Auto Setup

 

H-Pos

0

H-Size

0

V-Pos

0

V-Size

0

Clock Phase

0

Dot Clock

0

1:1 Pixel Mode

Off

Note:

Unadjustable items are grayed out. Adjustable items differ depending on the input signal and the display mode.

Note:

If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This picture position movement cannot be controlled by the Pos./Size function.

AUTO

H-Pos/V-Pos, H-Size/V-Size, Dot Clock and Clock Phase are automatically adjusted when the PC signal

SETUP

is received.

 

 

This setting only operates when a PC signal is input, and the aspect is “16:9”.

 

Using Remote Control

 

 

When

on the remote control is pressed, “Auto Setup” will be executed.

When Auto Setup does not work, “Invalid” is displayed.

Notes:

•Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright image with borders and other objects are clearly shown, and then try auto setup again.

•Depending on the signal, out of alignment may occur after Auto Setup. Carry out ¿ne tuning for the position/size as required.

•If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz and 1366×768@60Hz), pre-selecting the individual signal in “XGA MODE” (see page 39) may results in correct Auto Setup.

•Auto Setup does not work well when a signal such as additional information is superimposed out of valid image period or intervals between synchronizing and image signals are short.

•If Auto Setup cannot adjust correctly, select “Normalise” once and press ACTION () then adjust Pos./ Size manually.

•If the picture goes off screen in the horizontal direction as a result of performing Auto Setup, perform Dot Clock adjustment.

22