Options Adjustments
RS-232C/LAN Information Timing
Set up the informing manner for no signal or temperature rising.
While
While LAN controls: Acquire the warning or error message from the display.
| Options | 2/3 |
|
|
|
|
|
| Enable |
| |
| Initial Power Mode | Normal |
|
| ID select | 0 |
|
|
| ||
| Remote ID | Off |
|
| Serial ID | Off |
|
| Studio W/B | Off |
|
| LAN Control Protocol | Protocol 1 |
|
|
|
|
Press ACTION () button
|
|
|
| No Signal Warning | On |
| No Signal Warning Timing | 5min |
|
|
|
| No Signal Error | On |
| No Signal Error Timing | 10min |
|
|
|
| Temperature Warning | On |
| Temperature Warning Value | 55°C |
| Temperature Warning Release Value | 52°C |
1 | select |
2 | adjust |
If set to “On”, the display sends out the no signal warning.
No Signal Warning TimingSet up the detecting time for no signal warning.
No Signal ErrorIf set to “On”, the display sends out the no signal error.
No Signal Error TimingSet up the detecting time for no signal error.
The warning of “No Signal Warning” and the error of “No Signal Error” are not sent when the no signal state is detected through any of the following functions:
No Signal power off: Enable, PC Power management,
No Signal Warning Timing: 5 minutes
No Signal Error Timing: 10 minutes
PC Power management: On (30 seconds)
If there is no signal when PC IN is input, “PC Power management” is activated ¿rst and the Display enters the standby mode.
Note:
The “No Signal Error Timing” cannot be set shorter than “No Signal Warning Timing”.
Temperature WarningIf set to “On”, the display sends out the warning temperature.
Temperature Warning ValueSet up the detecting temperature for temperature warning.
Temperature Warning Release ValueSet up the temperature to release the temperature warning.
46