LAN Setup
Detailed network settings for the LAN established via the LAN terminal of the Display or twisted pair cable transmitter can be con¿gured.
Select “LAN Setup” and press 
.
LAN Setup
Save |
|
|
|
DHCP | Off |
|
|
IP address | 192.168. | 0. | 8 |
Subnet mask | 255.255.255. | 0 | |
Gateway | 192.168. | 0. | 1 |
Port | 1024 |
| |
DUPLEX | Auto |
| |
Network ID | 0 |
|
|
MAC Address | |||
DHCP, IP address, Subnet mask, and Gateway settings
1Set DHCP.
When “Off” is selected, IP address and other settings can be set manually.
2Select the item and press 
.
3Enter an address.
IP address | 1 | Use |
|
| to select a digit. | ||
I192.168. 0. 8 |
|
| |||||
| 2 | Use |
|
| to change a number. | ||
|
| ||||||
| 3 | Press |
|
| . | ||
|
|
| |||||
| Pressing |
| will cancel the address change. | ||||
4Select “Save” and press |
|
| . |
|
| ||
|
|
| |||||
|
|
| |||||
Port setting
1Select “Port” and press 
. 2Enter a port number.
Port | 1 | Use | to select a digit. |
I01024 | |||
| 2 | Use | to change a number. |
| 3 | Press | . |
Pressing 
will cancel the port number change.
Save | Port |
Save the current network Setup. Each value set for | Set the port number used for command control. |
DHCP, IP address, Subnet mask, and Gateway will be | The available setting range is 1024 – 65535. |
saved. If “NG” is displayed, check the same IP address | When the PJLink™ protocol is used, the port setting is |
is not used within the same network. | not necessary. |
DHCP (DHCP client function) | DUPLEX |
To obtain an IP address automatically using a DHCP | Set the connection speed of the LAN environment. |
server, set this to “On”. If DHCP server is not used, set | Select the value from Auto, 10 HALF, 10 FULL,100 HALF |
this to “Off”. | or 100 FULL. |
IP address (IP address display and setting) | Network ID |
Enter an IP address if DHCP server is not used. | Set the ID to identify this unit. |
Subnet mask (Subnet mask display and setting) | The available setting range is 0 – 99. |
|
Enter a subnet mask if DHCP server is not used.
Gateway (Gateway address display and setting) Enter a gateway address if DHCP server is not used.
MAC Address
Display the MAC address of this unit. However, the MAC address is not displayed when the “Control I/F Select” is set to
Notes:
•To use a DHCP server, make sure the DHCP server is started.
•Contact your network administrator for details on settings.
42