Panasonic TU-IRD20 manual Unpacking the Box, Installing Batteries Remote Control

BEFORE YOU BEGIN

Unpacking the Box

The following items come with your DSS® receiver:

• Receiver (access card inserted)		•	S-Video Cable
•	Remote Control	•	VCR Controller
•	Coaxial (RF) Cable	•	Audio/Video Cables

•Telephone Line Cord

		1				2	3
		4				5	6
		7				8	9
	R-TUNE					0	TV/VIDEO
	POWER						MUTE
				TV		CBL
	SS						RCV
	D					CH	R
POWER		VOL					VOL
	V					CH
RECALL	CR	1					LD
	MENU		VCR		2	AUX
	SELECT			SELECT
TV/DSS	GUIDE				MENU		EXIT
	FAV			RECALL			LOGO TUNE
Receiver	TV/VCR			ALT AUD.			TV/DSS
		REC				STOP	PAUSE
		REW				PLAY	FF

Remote Control	Panasonic
	DIGITAL SATELLITE
	RECEIVER

Installing Batteries In the

Remote Control

Follow these steps whenever you need to install or change the batteries in the remote control.

1.Remove the cover of the battery compartment.

2.Place batteries as shown, matching the + and - end of each battery in each compartment. Use alkaline batteries.

3.Replace the cover.

Precautions on Battery Use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control.

Observe the Following Precautions

•Batteries must be replaced as a pair.

•Do not combine a used battery with a new one.

•Do not mix battery types (for example, “zink carbon” with “alkaline”).

•Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

•Battery replacement is necessary when the remote control reacts sporadically or stops operating the receiver.

Audio/Video Cables Coaxial (RF) Cable

S-Video Cable

Telephone Line Cord

VCR Controller

AA Batteries

Press down here and slide cover back

4