Surround Sound
PICTURE |
|
|
|
SOUND |
|
|
|
SET UP |
|
|
|
|
|
| TV/AV |
TV/TEXT | F.P. | INDEX | HOLD |
|
| i |
|
100Hz/ |
| CH SEARCH | STILL |
PROGRE |
|
|
|
1 2 3
SURROUND
4 5 
6
ASPECT
7 8 9
SURROUND
Surround
This button switches the Dolby Virtual surround on and off. Please refer to page 20.
Stereo / Mono
Pressing the button changes the mode from Stereo (
) to Mono (
) and back again. Normally the television will detect whether the broadcast signal is Mono or Stereo and will set the mode accordingly. If the Stereo signal is weak or if the receiving conditions are not the best, it is recommended that the Mono mode be manually selected.
Bilingual *
This system allows two languages to be transmitted for one broadcast. Switching between the Main (I) and Sub (II) positions selects the desired languages.
*Note:
•Bilingual sound is currently not available in Australia or New Zealand.
Advanced Remote Control Operation
■Manufacturer’s Code Settings
This Remote Control has been designed to work with a variety of VCRs and DVD players. In order for this to occur, the setting for the VCR or DVD must be programmed into the Remote Control.
1.To set a VCR, slide the Remote Control 
to VCR.
To set a DVD, slide the Remote Control 
to DVD.
2. | Press the Remote Control | DVD | and keep it pressed. | |||
VCR | ||||||
3. | Enter the Manufacturer’s | |||||
| codes are shown below.) |
|
|
|
|
|
4. | Press the Stop button | . |
|
|
|
|
|
|
|
|
| DVD |
|
5.Release the Remote Control VCR or DVD Power button VCR .
6.Check the operation of the VCR or DVD. If it does not operate correctly, repeat steps 1 to 5 and use an alternate code (if there is one).
VCR Codes
Manufacturer | Code | Manufacturer | Code |
|
|
|
|
Panasonic/National | 10, 11, 12, 13 | NEC | 40, 41, 42, 43 |
AIWA | 15, 16 | ORION | 45, 46 |
FUJITSU | 20 | Philips | 50 |
HITACHI | 25, 26, 27 | SANYO | 55, 56, 57, 58 |
JVC | 30, 31, 32 | SHARP | 60, 61 |
MITSUBISHI | 35, 36 | SONY | 65, 66, 67 |
|
| TOSHIBA | 70, 71 |
|
|
|
|
DVD Codes |
|
|
|
Manufacturer | Code |
|
|
|
|
|
|
Panasonic | 70 |
|
|
|
|
|
|
Notes:
1.If the batteries are removed from the Remote Control, the Manufacturer’s codes are lost and must be reprogrammed.
2.The list of Manufacturer’s codes is given as a guideline only. Panasonic cannot guarantee that any other manufacturer’s product will work with this Remote Control.
29
