Panasonic VDR-D220 Screen indications in the video recording mode, Recording time elapsed

Recording

≥When about 5 minutes have passed without any operation in recording pause, the unit automatically turns off to prevent the battery from running down. When you want to use the unit, turn it on again. This setting can also be set to [OFF]. (l 92, [POWER SAVE])

Screen indications in the video recording mode

ARecording mode

BRemaining time left for recording

(When the remaining time is less than 1 minute, [R 0min] flashes red.)

CRecording time elapsed

A SP 0h00m10s

R 30min

B

C

≥The maximum number of scenes on a disc (per side): 999 (Even if there is remaining capacity for recording on a disc, you may not be able to record 999 scenes.)

≥Maximum number of dates on a disc (per side): 99 (Even if scenes are recorded on the same day, they may be grouped on a different recording date.) (l 61)

≥Sound is recorded in Dolby Digital from the internal stereo microphone on the front of the unit. Take care not to block this microphone.

≥Each time the unit enters the recording pause mode, the counter display will be reset to “0h00m00s”.

≥While motion picture recording is in progress, the recording will not stop even if the LCD monitor is closed and the viewfinder is retracted.

≥While “WRITING CONTROL DATA TO THE DISC. DO NOT SHAKE THE UNIT.” is displayed, do not disconnect the AC adaptor or remove the battery as doing so may make the disc unusable.

≥While motion picture recording is in progress, do not disconnect the AC adaptor or remove the battery. If you do, a repair disc message may be displayed when the power is turned back on. (l 97, About recovery)

The ACCESS/PC lamp lights immediately after recording finishes. While it lights, the disc is rotating and disc information is being recorded. If you run while holding the unit or swing it, the recorded images may be distorted so do not strongly shake or cause impact to it.

Recording modes and recordable time available for the motion picture

Changing the recording mode of the motion picture.

Press the MENU button, then select [BASIC] # [REC MODE] # desired item and press the joystick.

MENU

43

LSQT1146