Panasonic WV-CW504F Camera system setting SYSTEM SETUP, Synchronization method selection SYNC

Camera system setting [SYSTEM SETUP]

Performs the settings relating to the camera system such as synchronization, alarm input/output terminal, and privacy zone.

The following settings can be configured on the "SYSTEM SETUP" screen displayed from the top screen. Refer to page 5 for how to call up the screen.

"SYSTEM SETUP" screen

!0	**SYSTEM SETUP**
	SYNC	INT
!1 LENS		PANASONIC
!2	PRIVACY ZONE	OFF
!3	STABILIZER	OFF
!4	EL-ZOOM	OFF
!5 UPSIDE-DOWN		OFF

RET TOP END

10. Synchronization method selection [SYNC]

This unit supports the following 3 types of synchronization methods, and one of the following is selected.

(1)Multiplexed vertical drive signal (VD2)

(2)Synchronization is performed on the basis of the power supply frequency.

(3)Internal synchronization (INT) (default)

Input of a multiplexed vertical drive signal (VD2) automatically switches to the VD2 synchronization even if the camera is set to other than the VD2 synchronization method.

When other than the VD2 synchronization is selected, either the power supply synchronization or internal synchronization can be selected.

Note:

•The power supply synchronization (LL) setting is changeable only in the 60 Hz areas. The power supply synchronization (LL) can- not be setup in the 50 Hz areas.

Setting of the power supply synchronization (LL) mode

The adjusting video signal of the camera and the criterial external synchronizing input signal (power) are connected to a 2-input oscil- loscope and the phase is adjusted.

Note:

•Movement of the camera or presence of a spike noise in the power line may cause vertical phase change. In such a case, adjust the phase again.

Follow the procedure below.
"SYSTEM SETUP" screen		"SYNC" screen
**SYSTEM SETUP**			**SYNC**
SYNC	LL	V PHASE
LENS	PANASONIC
PRIVACY ZONE	OFF	COARSE			(1--16)
				1
STABILIZER	OFF	FINE	......128
EL-ZOOM	OFF
UPSIDE-DOWN	OFF		-			+
RET TOP END		RET TOP END

21