Panasonic WV-CW504FK manual Back focus setting BACK-FOCUSSETUP, Back focus adjustment, Step

Back focus setting [BACK-FOCUS SETUP]

Selects the back focus setting type and performs fine adjustment. The following setting can be configured on the "BACK-FOCUS SETUP" screen displayed from the top screen. Refer to page 5 for how to call up the screen.

The lens adjustment (☞ Installation Guide) shall be performed before the back focus adjustment.

<Back focus adjustment>

The back focus adjustment is performed by changing the distance between the lens and focal point.

Follow the procedure below.

Important:

•The auto back focus function is used for back focus adjustment at installation and for focus correction at switching between the color and black-and-white modes after installation. This function is not a function that is supposed to be operated continuously such as the auto focus function.

•When focus missing occurs due to secular change in the lens and installation environment or peripheral temperature change, the back focus adjustment is required again.

Note:

• The back focus adjustment can be also performed through the operation buttons. (☞ Installation Guide.)

"BACK-FOCUS SETUP" screen

**BACK-FOCUS SETUP**

ABF		PUSH	SW
MANUAL-ADJ
C/L	B/W	AUTO
SETUP-SW LOCK OFF
NEAR			FAR

..................

INDICATOR XXXX FOCUSING

RET TOP END

Step 1

Move the cursor to "PUSH SW" of "ABF" and press the setting button.

→The auto back focus function provides back focus adjustment to automatically focus on a subject located in the center of the screen.

Step 2

To fine adjust the back focus, move the cursor to "MANUAL-ADJ", press the setting button, and use the right or left button to adjust the back focus manually.

Note:

•Holding down the right and left buttons for more than 2 seconds simultaneously resets the back focus position to the CS mount default position.

•The value of "INDICATOR" is a guide to adjust the back focus. The larger the value is, the sharper the image becomes.

25