Panasonic WV-CW504SK, WV-CW504FK manual Image stabilizer setting STABILIZER, Step

Models: WV-CW504SK WV-CW504S WV-CW504F WV-CW504FK

1 32
Download 32 pages 38.96 Kb
Page 23
Image 23
13. Image stabilizer setting [STABILIZER]

Step 3

Move the cursor to "POSITION" and press the setting button.

Step 4

Use the up, down, right, and left buttons to determine the left upper position of the zone to be set and press the setting button.

Step 5

Use the up, down, right, and left buttons to determine the lower right position of the zone to be set and press the setting button.

The asterisk mark "*" will be displayed after the number and the zone setting will be saved.

Note:

To delete a zone, select the zone number and press the setting button after moving the cursor to "DEL".

To change the settings of a zone, select the zone number and repeat from step 3.

13. Image stabilizer setting [STABILIZER]

Whether or not to enable the image stabilizer is determined.

This function is effective for the case that the camera is installed on a power pole or other poles.

ON: Enables the image stabilizer.

OFF (default): Disables the image stabilizer.

Important:

When "ON" is selected for the image stabilizer, the view angle becomes narrower and the resolution becomes lower. When "ON" is selected for the image stabilizer, check the view angle and resolution at camera installation.

The image stabilizer function may not work for the following subjects or conditions:

Dark subject

Less contrasty subject (e.g. white wall)

Short cycled image shaking such as mechanical vibration

Large amplitude image shaking

23

Page 23
Image 23
Panasonic WV-CW504SK, WV-CW504FK manual Image stabilizer setting STABILIZER, Step