Step 4
Use the up, down, right, and left buttons to determine the left upper position of the area to be set and press the setting button.
Note:
•The area corresponding to the selected number will be displayed in a green frame, while the other set areas are shown in a white frame.
Step 5
Use the up, down, right, and left buttons to determine the right lower position of the area to be set and press the setting button.
→The asterisk mark "*" will be displayed after the number and the area setting will be saved.
Note:
•To delete the area, select the area number and press the setting button after moving the cursor to "DEL".
•To change the settings of the area, select the area number and repeat from step 3.
Setting of scene change detection
This function detects a change in the subject state that occurs by covering the camera with a cloth, a cap, or others, or by changing the camera direction largely.
Follow the procedure below.
"CAMERA SETUP" screen | ||||||||||||||
| **CAMERA SETUP** | |||||||||||||
SCENE1 |
|
|
|
|
|
|
| MOTION DET |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| |||||
ALC | ALC |
|
|
|
| OBJECT DET | OFF | |||||||
| ||||||||||||||
SHUTTER | OFF | SCENE CHANGE | OFF |
| ||||||||||
AGC | ON(HIGH) | INDICATOR | OFF | |||||||||||
SENS UP | OFF | |||||||||||||
WHITE BAL | ATW1 |
|
| ALARM | CONT | |||||||||
| ||||||||||||||
| ||||||||||||||
DNR | HIGH |
|
|
|
|
| ||||||||
BW MODE | AUTO1 |
|
|
|
|
|
|
| ||||||
|
|
|
|
|
| |||||||||
|
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
|
| RET TOP END |
|
| |||
RET TOP END |
|
|
|
|
|
|
|
|
|
Step 1
Move the cursor to
→The
Step 2
Move the cursor to "SCENE CHANGE" and select from the following.
ON: Provides an alarm signal when scene change is detected.
OFF (default): Disables scene change detection.
19