Step 6
Set the detection sensitivity and the minimum size of objects detected. Perform the setup while viewing the detection result displayed on the screen.
Set the detection sensitivity
Move the cursor to "SENSITIVITY" and select one of the following options for the detection sensitivity: LOW (default)/MID/HIGH
Set the minimum size of objects detected
Move the cursor to "MIN SIZE" and select the minimum size of objects detected from the following: The size options will be displayed in a green frame in the center of the screen. In "OFF" position, any object will be detected regardless of its size.
Perform the setup while viewing the detection result displayed on the screen. OFF (default)/SMALL/MEDIUM/LARGE
Note:
•The detection sensitivity and minimum size selected in this step will be applied to all the alarm actions selected in step 3.
•The detection areas set in step 4 will be displayed as a white frame on the "SENSITIVITY" screen.
•When a motion is detected, a blue frame appears and changes to a red frame after a given time (approx. 1 second.) on the
"SENSITIVITY" screen. In operation, an alarm signal is provided when the frame changes to red.
Perform the settings relating to the detection of appearance/disappearance of stationary objects
Perform the settings relating to the detection of appearance/disappearance of stationary objects as follows. Up to 4 appearances/ disappearances of stationary objects can be simultaneously detected. However, use of the scene change detection function decreases the maximum simultaneous detectable appearances/disappearances of stationary objects to 3.
Follow the procedure below.
"CAMERA SETUP" screen | "OBJECT" screen | "SENSITIVITY" screen | ||||||||||
| **CAMERA SETUP** | **OBJECT DET**(1) | **SENSITIVITY**(1) | |||||||||
SCENE1 |
| MOTION DET |
|
| REMOVAL AND LEFT BEHIND | MIN SIZE | OFF |
| ||||
| ALC | ALC | OBJECT DET | ON |
|
|
|
|
|
|
| |
| SHUTTER | OFF | SCENE CHANGE | OFF |
| DURATION TIME | 10s |
|
|
| ||
| AGC | ON(HIGH) | INDICATOR | OFF | AREA | ALL |
|
|
| |||
| SENS UP | OFF | SENSITIVITY |
|
|
|
|
| ||||
| WHITE BAL | ATW1 | ALARM | CONT |
|
|
|
|
|
| ||
| DNR | HIGH |
|
|
|
|
|
|
|
|
| |
| BW MODE | AUTO1 |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
| RET TOP END |
| RET TOP END |
|
| RET TOP END |
| RET TOP END |
|
|
Step 1
Move the cursor to
→The
Step 2
Move the cursor to "OBJECT DET" and press the setting button.
→The "OBJECT DET" screen appears.
Step 3
Move the cursor to "DURATION TIME" and select the wait time of appearance/disappearance of stationary objects from the following. 10 s (default)/20 s/30 s/40 s
17