27 | 13 | PUSH/PULL |
CABLE | ||
DETAIL |
|
|
23 |
| 1/4” NUTS |
|
| DONOTOVERTIGHTEN! |
| SPRING PIN | |
| ASSEMBLY | |
FIGURE 25 13 |
| DETAIL 25 |
STEP 23
•SECURELY assemble the SPRING PIN ASSEMBLY of the PUSH/PULL CABLE to the SPRING PIN BARREL on the RECEIV-
ING TUBE (13). (!!! IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLY SECURELY)
•Swing the PRESS ARM (27) up until the SPRING PIN of the PUSH/PULL CABLE engages in one of the adjustment holes.
•Thread the second
TANT!DONOTOVERTIGHTENNUTS!)
•Use the extra thread on the end of the CABLE to adjust out slack. ( !!! DO NOT ADJUST OUT TO FAR !!! ALWAYS ALLOW SPRING PIN ASSEMBLY TO FULLY ENGAGE)
|
|
|
| STEP 26 |
|
|
3/8 X |
|
| • SECURELY assemble the SEAT PAD (40) to the | |||
91 |
| BACK PAD ADJUST (16) using four 3/8 X | ||||
|
| 16 | 40 | BOLTS (83) and four 3/8” WASHERS (91). See | ||
|
|
|
| FIGURE26. |
|
|
25 |
|
|
| • SECURELY assemble one 3/8” SPRING PINASSEM- | ||
|
|
| BLY (51) to the FRONT UPRIGHT (25) as shown in | |||
51 |
|
|
| |||
|
|
| FIGURE26. |
|
| |
|
|
|
|
|
| |
|
|
|
| • Attach one | ||
|
|
|
| (25) as shown in FIGURE 26. |
| |
61 |
|
|
| • Insert the SEAT PAD (40) & BACK PAD ADJUST | ||
|
|
|
| |||
|
|
|
| (16) into the FRONT UPRIGHT (25) while pulling back | ||
|
|
|
| on the SPRING PIN ASSEMBLY (51) until it engages | ||
|
|
|
| in one of the adjustment holes. See FIGURE 26. | ||
FIGURE 26 |
|
|
|
|
|
|
1/2 | 1/2 | 1/2 | 1/2 | 4 | 1/2 | 1/2 |
0 | 1 | 2 | 3 | 5 | 6 | |
|
|
| 23 |
|
|
|
