ParaBody 425104 manual PEC Cable

	42
	92
	98
	91
	84 3/8 X 2”
FIGURE 40	29

STEP 40

•Assemble one 3-1/2” PULLEY (42) around the PEC DEC CABLE (98) and to the PULLEY BRACKET (29) using one 3/8 X 2” BOLT (84), two 3/8” WASHERS (91) and one 3/8” LOCKNUT (92) as shown in FIGURE 40.

26
98	24
98
PEC
CABLE
	FIGURE 41
STEP 41

•Slide the ends of the PEC DEC CABLE (98) into the bushings on the PEC CAMS (24) as shown on FIGURE 41.

•Lay the PEC DEC CABLE (98) over the pulleys and under the cable retaining clips in the CENTER PULLEY BRACKET (26) as shown in FIGURE 41. (NOTE: Securely tighten the pulley connections in the CENTER PULLEY BRACKET (26). The cable retaining clips should be at approximately a 45° angle.)

	1/2		1/2		1/2		1/2		1/2		1/2
0		1		2		3		4		5	6

36