29 |
AC |
AF |
** |
AQ |
AE |
AD |
GS4SHROUD |
BRACKET |
OPTION ONLY |
B |
FIGURE 4 |
STEP 4:
•Insert two GUIDE RODS (AC) into the BASE FRAME (B) as shown on FIGURE 4. (NOTE: If the GS4 SHROUD OPTION was purchased, place the GUIDE RODS (AC) through the BOTTOM SHROUD BRACKET (found in SHROUD OPTION box) and into the BASE FRAME (B) as shown in FIGURE 4.
•(NOTE: Lubricate GUIDE RODS (AC) with silicon or teflon spray available at most hardware stores.)
•Slide two WEIGHT STACK SPACERS (AD) and two WEIGHT STACK CUSHIONS (AE) down over the GUIDE RODS (AC).
•Using EXTREME CARE slide all fifteen WEIGHT PLATES (**) down over the GUIDE RODS (AC) on to the WEIGHT STACK CUSHIONS (AE). Make sure that the WEIGHT PLATES (**) are all facing as shown.
•Slide the head plate assembly down over the GUIDE RODS (AC) onto the weight stack.
•Slide two SHAFT COLLARS (29) over the GUIDE RODS (AC) as shown in FIGURE 4.
•Apply WEIGHT STACK LABELS (AQ) to WEIGHT PLATES (**) and HEAD PLATE (AF) as shown in FIGURE 4. Begin with number one at the HEAD PLATE (AF) with larger numbers in consecutive order towards bottom of weight stack.
7
