3/8 X 3/4” | 3/8” LOCK WASHER |
ALLEN SCREW | PRESSARM PIVOT SHAFT |
| |
| Y |
| SPRING PIN |
| X |
| H |
FIGURE 13 |
|
STEP 13: |
|
•Disassemble the PRESS ARM PIVOT SHAFT from the PRESS ARM (H) by removing the two 3/8 X 3/4” ALLEN SCREWS and two 3/8” LOCK WASHERS as shown in FIGURE 13.
•Insert the PRESS ARM PIVOT SHAFT thru the PRESS ARM (H) and the PRESS ARM SUPPORT FRAME (X) and the resassemble the 3/8 X 3/4” ALLEN SCREWS and 3/8” LOCK WASHERS to the PRESS ARM PIVOT SHAFT as shown in FIGURE 13. (Note: Tighten this connection enough to remove excess play yet allow the PRESSARM to rotate freely.)
•Pull back on the SPRING PIN and rotate the PRESS ARM (H) until the SPRING PIN connects with the ROM PLATE (Y)
14
