7.Verify the connection. Turn your power source ON. The PWR (power) LED on your SMD2000-24T faceplate will illuminate solid green to indicate that the chassis is receiving power.
Connecting the SHDSL RJ21 Cable
Procedure
To connect the SHDSL cable to the SMD2000-24T RJ21 connector:
1.Configure the SHDSL lines.
No configuration is necessary for the SMD2000-24T to operate at default settings. However, if you wish to run subscriber lines at settings other than the SMD2000-24T defaults, configure the subscriber lines prior to connection. Parameter settings may be changed using the Command Line Interface (CLI), Simple Network Management Protocol (SNMP), or the web-based management system. SHDSL Parameter Defaults on page 15 lists the device defaults. Product Documentation Online on page 3 lists the user interface manuals.
2.Detach the hook-and-loop fastener strap from the RJ21 socket on the front of the chassis and pull it upward, leaving it looped under the connector frame at the top.
