Patton electronic 2710 Unit Options, a Header Line 1 & Header Line, b Password, c Loop Timeout

3.2.4 Unit Options

The Unit Options screen looks like this (factory default):

aHeader Line 1 & Header Line 2

Headers 1 and 2 are provided for easy identification of your unit after installation. You may want to give each unit a unique name via the header lines to help distinguish one unit from another. You can enter a header up to 40 letters long. Two lines provide 80 letters for your use. That’s a lot of flexibility!

bPassword

The Password facility provides security by allowing only those who know the correct password to configure the unit via the control port. You can still configure the unit via the DIP switches. The password can be up to 16 characters long, with no restriction on the combination of characters you can use, so be sure to remember the password. If you lose your password, you will lose the ability to access the unit via the control port.

cLoop Timeout

The Loop Timeout setting can be set to one of the following:

00:05 =	five minutes
00:10 =	ten minutes
00:15 =	fifteen minutes
00:30 =	thirty minutes (default setting)
00:45 =	forty-five minutes
01:00 =	one hour
01:30 =	90 minutes
02:00 =	two hours
03:00 =	three hours
NEVER =	forever—the unit will remain in loopback without user
	intervention.

dSet to Default Configuration

You may set the NetLink-T1™ to its factory default configuration, except for the header lines and the password, by executing the Set to Default Configuration command.

eService Information

If you need to contact us for help, you can view the Service Information screen. Here is what it looks like:

29 30