USER MANUAL
MODEL 2710 Series
NetLink-T1
T1/Fractional T1 CSU/DSU
TABLE OF CONTENTS
1.1 WARRANTY STATEMENT
Section
Page
1.3 RADIO AND TV INTERFERENCE
1.4 FCC INFORMATION
1.4.1 FCC Compliance
1.5 INDUSTRY CANADA NOTICE
1.6 SERVICE INFORMATION
2.1 FEATURES
tel 301 email support@patton.com
Monday through Friday
3.0 CONFIGURATION
3.1 DIP SWITCH CONFIGURATION
2.3 SUPPORTED APPLICATIONS
2.3.1 The 2710 as the Interface between the Telco and CPE
SWITCH SET SUMMARY TABLE
Switches SW1, SW2, and SW3
Switch SW4 Line Framing and Coding
Switch SW5 DS0 Channel Rate
Switch SW6 Clock Mode
Switches SW7 and SW8 Line Build Out
3.2 SOFTWARE CONFIGURATION
VT100
3.2.1 Introduction to Main Menu
HELPFUL HINTS
3.2.2 System Configuration
a Line FormatESF default Options ESF, D4, UNFRAMED
b Line Coding B8ZS default Options AMI, B8ZS, B7ZS
c DS0 Line Rate 64kbps default Options 64kbps, 56kbps
g ESF Carrier Loops Enabled default Options Enabled, Disabled
Options Network, Internal, External
15.0 dB -22.5 dB
f ESF Data Link ANSI T1.403 Options ANSI T1.403, AT&T TR54016
j Default Config Source EEPROM Option EEPROM, Switch
h Remote In-band Loops Enabled default Options Enabled, Disabled
i V.54 Loops Enabled default Options Enabled, Disabled
3.2.3 System Diagnostics
a Local Loop Idle default
b Remote Loop Idle default
c spacebar
c Test Pattern Idle default Options Idle or Sending
d Error Insertion Off default Options On, Off
e Selected Pattern
NI STATUS
Error Counters
Current DIP Switch Settings
Valid Interval Count & Current Interval Time
Rx PRM
b Password
c Loop Timeout
d Set to Default Configuration
e Service Information
4.3 POWER CONNECTION
4.3.1 Using the AC Power Supply 120VAC or 100-240VAC
4.3.2 Supplying DC Power
4.3.3 Supplying Power via pin KK
5.1 LED DESCRIPTIONS
5.2 LOOP V.54 & TELCO DIAGNOSTICS
5.2.1 Operating Local Loopback LL
5.2.2 Operating Remote Digital Loopback RL
5.2.3 Central Office Loops
5.3 BIT ERROR RATE V.52 DIAGNOSTICS
d Error Insertion to ON
PATTON NETLINK-T1 MODEL SPECIFICATIONS
Diagnostics
Wire Gauge
APPENDIX C PATTON NETLINK-T1 MODEL FACTORY REPLACEMENT PARTS
AND ACCESSORIES
PATTON NETLINK-T1 MODEL CABLE RECOMMENDATIONS
RS-232 Control Port Signals at DB-25 Connector
RS-232 Control Port Signals at DB-9 Connector
M/34 Connector, Terminal Interface
PATTON NETLINK-T1 MODEL INTERFACE PIN ASSIGNMENT
PATTON NETLINK-T1 MODEL POWER SUPPLY INTERFACE
Jumper Position for Power via DC Power Jack default
Jumper Position for Power via Pin KK
Copyright Patton Electronics Company All Rights Reserved