Patton electronic 2710 Table Of Contents, Section, Page, General Information, Warranty Statement

		TABLE OF CONTENTS
	Section		Page
1.0	General Information		2
	1.1	Warranty Statement
	1.2	CE Notice
	1.3	Radio and TV Interference
	1.4	FCC Information
		1.4.1 FCC Compliance
	1.5	Industry Canada Notice
	1.6	Service Information
2.0	General Information		6

2.1Features

2.2General Product Description

2.3Supported Applications

2.3.1The 2710 as the Interface Between the Telco and CPE

2.3.2The 2170 as High-Speed Short Range Modem

3.0 Configuration 8

3.1DIP Switch Configuration

3.2Software Configuration

3.2.1Introduction to Main Menu

3.2.2System Configuration

3.2.3Systems Diagnostics

3.2.4Unit Options

4.0 Installation 31

4.1DTE Interface Connection

4.2Network Interface Connection

4.3Power Connection

4.3.1Using the AC Power Supply (120VAC or 100-240VAC)

4.3.2Supplying DC Power

4.3.3Supplying Power via Pin KK

5.0 Operation 33

5.1LED Descriptions

5.2Loop (V.54 & Telco) Diagnostics

5.2.1Operating Local Loopback (LL)

5.2.2Operating Remote Digital Loopback (RL)

5.2.3Central Office Loops

5.3Bit Error Rate (V.52) Diagnostics

Appendix A - Specifications	38
Appendix B - Cable Recommendations	39
Appendix C - Factory Replacement Parts and Accessories	40
Appendix D - Interface Pin Assignments	41
Appendix E - Power Supply Interface	43
1

1.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warrant- ed for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to con- tact Patton Electronics Technical Services at (301) 975-1007.

1.1 WARRANTY STATEMENT

Patton Electronics warrants all Model 2710 Series components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.This warranty is limited to defects in workmanship or materi- als, and does not cover customer damage, abuse, or unauthorized modification. This product contains no serviceable parts; therefore the user shall not attempt to modify the unit in any way. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequential damages aris- ing from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user. In the event the user detects intermittent or continuous product malfunction due to nearby high power transmitting radio frequency equipment, the user is strongly advised to use only data cables with an external outer shield bonded to a metal or metal- ized connector.

1.2 CE NOTICE

The CE symbol on your Patton Electronics equipment indicates that it is in compliance with the Electromagnetic Compatibility (EMC) directive and the Low Voltage Directive (LVD) of the Union European (EU). A Certificate of Compliance is available by contacting Patton Technical Support.

WARNING! This device is not intended to be con- nected to the public telephone network in Europe.

2