MODEL 2710 Series
USER MANUAL
NetLink-T1
T1/Fractional T1 CSU/DSU
1.1 WARRANTY STATEMENT
TABLE OF CONTENTS
Section
Page
1.4 FCC INFORMATION
1.3 RADIO AND TV INTERFERENCE
1.4.1 FCC Compliance
1.5 INDUSTRY CANADA NOTICE
2.1 FEATURES
1.6 SERVICE INFORMATION
tel 301 email support@patton.com
Monday through Friday
3.1 DIP SWITCH CONFIGURATION
3.0 CONFIGURATION
2.3 SUPPORTED APPLICATIONS
2.3.1 The 2710 as the Interface between the Telco and CPE
Switches SW1, SW2, and SW3
SWITCH SET SUMMARY TABLE
Switch SW4 Line Framing and Coding
Switch SW5 DS0 Channel Rate
Switches SW7 and SW8 Line Build Out
Switch SW6 Clock Mode
3.2 SOFTWARE CONFIGURATION
VT100
HELPFUL HINTS
3.2.1 Introduction to Main Menu
a Line FormatESF default Options ESF, D4, UNFRAMED
3.2.2 System Configuration
c DS0 Line Rate 64kbps default Options 64kbps, 56kbps
b Line Coding B8ZS default Options AMI, B8ZS, B7ZS
Options Network, Internal, External
g ESF Carrier Loops Enabled default Options Enabled, Disabled
15.0 dB -22.5 dB
f ESF Data Link ANSI T1.403 Options ANSI T1.403, AT&T TR54016
h Remote In-band Loops Enabled default Options Enabled, Disabled
i V.54 Loops Enabled default Options Enabled, Disabled
j Default Config Source EEPROM Option EEPROM, Switch
a Local Loop Idle default
3.2.3 System Diagnostics
b Remote Loop Idle default
c spacebar
d Error Insertion Off default Options On, Off
c Test Pattern Idle default Options Idle or Sending
e Selected Pattern
NI STATUS
Current DIP Switch Settings
Error Counters
Valid Interval Count & Current Interval Time
Rx PRM
c Loop Timeout
b Password
d Set to Default Configuration
e Service Information
4.3.1 Using the AC Power Supply 120VAC or 100-240VAC
4.3 POWER CONNECTION
4.3.2 Supplying DC Power
4.3.3 Supplying Power via pin KK
5.1 LED DESCRIPTIONS
5.2.1 Operating Local Loopback LL
5.2 LOOP V.54 & TELCO DIAGNOSTICS
5.2.2 Operating Remote Digital Loopback RL
5.2.3 Central Office Loops
d Error Insertion to ON
5.3 BIT ERROR RATE V.52 DIAGNOSTICS
PATTON NETLINK-T1 MODEL SPECIFICATIONS
Diagnostics
APPENDIX C PATTON NETLINK-T1 MODEL FACTORY REPLACEMENT PARTS
Wire Gauge
AND ACCESSORIES
PATTON NETLINK-T1 MODEL CABLE RECOMMENDATIONS
RS-232 Control Port Signals at DB-9 Connector
RS-232 Control Port Signals at DB-25 Connector
M/34 Connector, Terminal Interface
PATTON NETLINK-T1 MODEL INTERFACE PIN ASSIGNMENT
Jumper Position for Power via DC Power Jack default
PATTON NETLINK-T1 MODEL POWER SUPPLY INTERFACE
Jumper Position for Power via Pin KK
Copyright Patton Electronics Company All Rights Reserved