Patton electronic 4630 Series manual Connecting the SmartNode to your laptop PC

SmartNode 4630 Getting Started Guide 4 • Initial configuration

Introduction

This chapter leads you through the basic steps to set up a new SmartNode and to download a configuration. Setting up a new SmartNode consists of the following main steps:

Note If you haven’t already installed the SmartNode, refer to chapter 3, “SmartNode installation” on page 23.

•Connecting the SmartNode to your laptop PC

•Configuring the desired IP address

•Connecting the SmartNode to the network

•Loading the configuration (optional)

Note The SmartNode CD-ROM contains a collection of third party software tools (including TFTP servers and Telnet utilities) to help you configure, operate and monitor the SmartNode device.

1. Connecting the SmartNode to your laptop PC

First the SmartNode must be connected to the mains power supply with the power cable. Wait until the Power LED stops blinking and stays lit constantly. Now the SmartNode is ready.

The interconnecting cables shall be acceptable for external use and shall be rated for the proper application with respect to volt- age, current, anticipated temperature, flammability, and

CAUTION mechanical serviceability.

When this device is used in North America, it shall be connected to a Network Termination Device and not connected directly to an outside POTS line.

CAUTION

The SmartNode 4630 Series is equipped with Auto-MDX Ethernet ports, so you can use straight-through cables for host or hub/switch connections (see figure 7).

Straight-through wired cable

LAN (ETH 0/1)

Laptop PC

Figure 7. Connecting the SmartNode to your laptop PC

The SmartNode comes with a built-in DHCP server to simplify configuration. Therefore, to automatically configure the PC for IP connectivity to the SmartNode, the laptop PC must be configured for DHCP. The

Introduction 29