Introduction, Power up the NTU | Patton electronic Model 3088/I

3088/I Getting Started Guide	2 • Initial configuration

Introduction

The Model 3088/I (see ﬁgure 2) has two conﬁguration modes: RS-232 console and web page GUI software.

Figure 2. Model 3088/I

The RS-232 console is used for the initial conﬁguration of the IP address and mask. Subsequently the easiest method is to use a standard web browser to complete the conﬁguration.

The 3088/I is Plug ‘n’ Play with the Model 3096RC G.SHDSL concentrator card or compatible G.SHDSL card.

Power up the NTU

Your NTU comes with an external AC adaptor with detachable power cord. (Also refer to “Power-up”on page 33.)

Ensure that the power cable used with the external power adapter meets all applicable standards for the country in which it is to be installed, and that it is connected to a wall outlet which has earth ground.

WARNING

AC power-up

1.Connect female plug of the AC power cord to the AC adaptor provided.

2.Connect the barrel-type connector of the AC adaptor to the barrel-type power jack on the RocketLink-G NTU.

3.Insert the male plug of the AC power cord into an AC power outlet (100–240 VAC).

DC power-up

The 36-60 VDC DC to DC adapter is supplied with the DC version of the Model 3088/I. The black and red leads plug into a DC source (nominal 48VDC) and the barrel power connector plugs into the barrel power supply jack on the 3088/I. (See ﬁgure 3).

Introduction

Patton electronic Model 3088/I manual Introduction, Power up the NTU, AC power-up, DC power-up

Models: Model 3088/I

Introduction

Figure 2. Model 3088/I

Power up the NTU

AC power-up

DC power-up