Patton electronic Model 3088/I Configure the IP address, Power-up indication, Connect a PC and log

3088/I Getting Started Guide 2 • Initial configuration

To Power

Supply Jack

Barrel power connector

MADEINCHINABYSUNNY	:G01234567890S/N	OUTPUTPOWER:5WMAX	OUTPUT:+5V1.0A	INPUT:36-60V0.2AMAX	MODEL:SYD1106-0505	SWITCHINGPOWERSUPPLY		To -48VDC
							-Vin	Source
							+Vin

Black lead (-V)

Red lead (+V)

Figure 3. DC Power Supply

There are no user-servicable parts in the power supply section of the Model 3088/I. Fuse replacement should only be performed by qualified service personnel. See Chapter 8, “Contacting Pat-

WARNING ton for assistance” on page 64.

Power-up indication

The Power and 100M Ethernet LEDs are lit while the RocketLink-G is powering up.

Configure the IP address

The RocketLink-G NTU is shipped with a factory-configured IP address assigned to the Ethernet LAN port (green outline). The address is 192.168.200.10/24. In most cases, you must change the address to be on the same subnet as your PC, as described in the procedures below. If you are not sure which IP address to use for your installation, contact your network administrator.

Connect a PC and log in

Using the included combination RS-232/Ethernet cable and DB9-RJ45 adapter, connect a PC’s serial port to the RocketLink-G’s Console port (red outline) (see figure 4).

The interconnecting cables shall be acceptable for external use and shall be rated for the proper application with respect to volt- age, current, anticipated temperature, flammability, and

CAUTION mechanical serviceability.

Line

Ethernet	-X
	MDI

Console

Power

PC with

terminal emulator

Serial port

Connect to Console port

Figure 4. Connecting RocketLink-G NTU to the PC’s serial port

Configure the IP address 18