Patton electronic Model 3088/I instruction

3088/I Getting Started Guide	2 • Initial configuration

Note If two RocketLink-G NTUs are connected back-to-back, one must be con- ﬁgured as Remote, the other as Central.

7.The WAN Link LED will ﬂash while in the process of establishing a link. The LED will be on constantly once a valid DSL connection is established.

Line

Ethernet	-X
	MDI

Console

Power

Figure 7. Rear view of 3088/I showing DSL RJ-11 jack

Configure the IP address

21

Image 21

Patton electronic Model 3088/I manual Rear view of 3088/I showing DSL RJ-11 jack

Contents

RocketLink-G G.SHDSL NTU Mailsupport@patton.com Summary Table of Contents Table of Contents Installation & operation Factory replacement parts and accessories RS-232 console interface pin assignments List of Figures List of Tables About this guide AudienceStructure Impaired functioning Precautions General observations Safety when working with electricity General conventions Typographical conventions used in this document General information Chapter contents RocketLink-G 3088/I overview Features Initial conﬁguration AC power-up Power up the NTUDC power-up Introduction Power-up indication Conﬁgure the IP addressConnect a PC and log Connect to the local IP network Modify the IP address Connect the G.SHDSL port Log onto the web management interface Rear view of 3088/I showing DSL RJ-11 jack Shdsl conﬁg and status DSL Parameters DSL conﬁguration DSL Error Monitor Conﬁguration DSL Error Monitor Conﬁguration Run-Time Statistics Shdsl Status Local Interface Error Counters DSL Line Error Counters Clearing the error counters Clearing Error Counters Ethernet & WAN PPP Conﬁg and status PPP conﬁguration IP conﬁgurationEthernet port conﬁguration Ethernet Basic Port Attributes Ethernet performance statistics Ethernet Advanced Port Attributes Conﬁgurable Ethernet parameters Installation & operation Power-up InstallationConnecting the twisted-pair interface Operation LED status indicators Power YellowWAN LEDs 100M Yellow Ethernet LEDs System Management 3088 RocketLink-G Plug ‘n’ Play Reset for Factory Default Saving the conﬁgurationConsole Backing up and restoring saved conﬁgurations Authentication Upgrading software on the 3088/I System Software Upgrade Diagnostic tools System tools for testing LED status monitor & deﬁnitionPing & Traceroute Contacting Patton for assistance Warranty coverage Contact informationPatton support headquarters in the USA RMA numbers Out-of-warranty service Appendix a Compliance information Compliance SafetyFCC Part 68 Acta Statement Radio and TV Interference FCC Part Industry Canada Notice CE Declaration of ConformityAuthorized European Representative Appendix B Speciﬁcations Shdsl characteristics General characteristicsEthernet Protocol support Diagnostics Serial connectorManagement 10Base-T/100Base-TX interface VDC power supply PowerEthernet 100M Ethernet Tx Line Interface DimensionsEnvironment Shdsl Physical connection & Transmission Line Appendix C Factory replacement parts and accessories Model # Description Factory replacement parts and accessories Appendix D RJ-11 non-shielded DSL port RJ-11 non-shielded DSL port Appendix E RJ-45 shielded 10/100 Ethernet port RJ-45 shielded 10/100 Ethernet port Appendix F RS-232 console interface Pin assignments RS-232 console interface pin assignments RJ-45 non-shielded Connector EIA-561