Patton electronic Model 3088/I manual Management, 10Base-T/100Base-TX interface, Serial connector

3088/I Getting Started Guide B • Specifications

Management

•Web-based configuration via embedded web server

•CLI menu for configuration, management, and diagnostics

•Local (VT-100 or Telnet)

•Console port set at 9600 bps, 8 bits, no parity, 1 stop bit, no flow control

10Base-T/100Base-TX interface

The Ethernet port is a shielded RJ-45 jack, autonegotiate, full- or half-duplex with an MDI-X switch. See Appendix E, “RJ-45 shielded 10/100 Ethernet port” on page 58 for the pinout.

Serial connector

The console port is an RS-232 interface (EIA-561) on an RJ-45 jack. See Appendix F, “RS-232 console inter- face pin assignments” on page 60 for the pinout.

Diagnostics

Various diagnostic features are integrated into the 3088/I NTU. Ping and Traceroute facilities. DSL run-time statistics, DSL line error counters, Local interface error counters, Bridged PPP statistics, Ethernet port statis- tics, and front panel status LEDs (see section“Status LEDs”.)

Status LEDs

Power

The Power LED glows solid during normal operation. At startup, during the POST, the LED blinks once every second. If the POST fails, the unit does not enter normal operation, and the LED blinks once every 0.4 seconds.

WAN Link

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

WAN Tx

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

WAN Rx

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

Ethernet Link

The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once every second.

Management 51