Patton electronic Model 3101RC manual Web GUI

Model 3101RC Getting Started Guide3 • Configuration

local:%configure

local:(conf)#runningcfg write partition 1

Are you sure write running configuration to Flash ROM partition #1 ? (Y/[N])y System writing Flash ROM partition #1...

Write running configuration to Flash ROM partition #1 success! local:(conf)#exit

local:%ping 172.16.10.72

PING 172.16.10.72 (172.16.10.72): 56 data bytes

64 bytes from 172.16.10.72: icmp_seq=0 ttl=64 time=8.7 ms

64 bytes from 172.16.10.72: icmp_seq=1 ttl=64 time=0.8 ms

64 bytes from 172.16.10.72: icmp_seq=2 ttl=64 time=0.8 ms

64 bytes from 172.16.10.72: icmp_seq=3 ttl=64 time=0.8 ms

--- 172.16.10.72 ping statistics ---

4 packets transmitted, 4 packets received, 0% packet loss round-trip min/avg/max = 0.8/2.7/8.7 ms

local:%

Now you can access the Model 3101 via Telnet on port 23 (for using CLI) or Web GUI interface by entering the IP address of 3101 in your browser's URL/address field.

Web GUI

Use the following commands to provision an IP port in the Web GUI:

1.On the menu tree, click on System > Board Setup. The Board Setup page is displayed.

Figure 10. Board IP Setup

2.Type in new IP setting in the GBE (In Band) section for in-band IP provisioning.

3.Type in new IP setting in the MGMT (Out Band) section for out-band IP provisioning.

4.Click on Modify to submit the modification.

Provisioning a Management IP Port 23