Problem | Action | |
|
| |
Printing stops and | Calibrate the supply. | |
indicator light turns | 1. Turn off the printer. | |
RED. | 2. Load supply for | |
Or, | ||
See Chapter 3, “Loading | ||
Printing is not lined | Supplies,” for more information. | |
up correctly on | 3. Press and hold the FEED | |
supply. | button while turning on the | |
| printer. | |
| 4. Release the FEED button after | |
| the indicator light starts | |
| flashing ORANGE. The printer | |
| calibrates the black mark or die | |
| cut sensor, measures the label | |
| length, prints the test labels, | |
| and calibrates the ribbon | |
| sensor. | |
| 5. To resume normal printing, turn | |
| off the printer, wait two | |
| seconds, then turn it back on. | |
| Problem with the supply. Load | |
| different supply. See Chapter 3, | |
| “Loading Supplies” for more | |
| information. | |
| Make sure the ribbon is not empty. | |
|
| |
| Make sure the black mark/die cut | |
| sensor is set correctly for your | |
| supply type. See “Adjusting the | |
| Black Mark/Die Sensor,” for more | |
| information. | |
| Clear a label jam. See “Clearing | |
| Supply Jams,” in Chapter 5 for more | |
| information. |